关于“设置 Kubernetes 专用集群”的评价

Huy T. · 已于 about 7 years前审核

Hemanth K. · 已于 about 7 years前审核

good!

mujtaba a. · 已于 about 7 years前审核

I don't know enough to finish this lab. This is my fault, not yours.

Draconis N. · 已于 about 7 years前审核

Mehrajuddin H. · 已于 about 7 years前审核

Mehrajuddin H. · 已于 about 7 years前审核

Sagnik C. · 已于 about 7 years前审核

amazing

abdul saboor h. · 已于 about 7 years前审核

very helpful

Kamal E. · 已于 about 7 years前审核

ok

Tung N. · 已于 about 7 years前审核

ok

Tung N. · 已于 about 7 years前审核

Mehrajuddin H. · 已于 about 7 years前审核

Mehrajuddin H. · 已于 about 7 years前审核

Eric T. · 已于 about 7 years前审核

Chris H. · 已于 about 7 years前审核

Hieu N. · 已于 about 7 years前审核

Alexsander H. · 已于 about 7 years前审核

Murat S. · 已于 about 7 years前审核

Bernard P. · 已于 about 7 years前审核

ghulam reza r. · 已于 about 7 years前审核

JEAN-LUC R. · 已于 about 7 years前审核

Awesome Quest

furkan b. · 已于 about 7 years前审核

Not clearly described where [MY_EXTERNAL_RANGE] should be taken in the last steps. There is no external address in the output as was mentioned.

Vadym Z. · 已于 about 7 years前审核

oops

Jason Thino K M. · 已于 about 7 years前审核

I cannot figure out that last step. The instructions are way too vague on what to use for the external IP range. I have gone through every IP range in the console output, I've looked at the subnets listing again, etc. There need to be examples or an indication of what output to use.

Jamie D. · 已于 about 7 years前审核